Undo git pull, how to bring repos to old state

A more modern way to undo a merge is:

git merge --abort

And the slightly older way:

git reset --merge

The old-school way described in previous answers (warning: will discard all your local changes):

git reset --hard

But actually, it is worth noticing that git merge --abort is only equivalent to git reset --merge given that MERGE_HEAD is present. This can be read in the git help for merge command.

git merge --abort is equivalent to git reset --merge when MERGE_HEAD is present.

After a failed merge, when there is no MERGE_HEAD, the failed merge can be undone with git reset --merge but not necessarily with git merge --abort, so they are not only old and new syntax for the same thing. This is why i find git reset --merge to be much more useful in everyday work.

Same as jkp's answer, but here's the full command:

git reset --hard a0d3fe6

where a0d3fe6 is found by doing

git reflog

and looking at the point at which you want to undo to.

it works first use: git reflog

find your SHA of your previus state and make (HEAD@{1} is an example)

git reset --hard HEAD@{1}

Running git pull performs the following tasks, in order:

1. git fetch
2. git merge

The merge step combines branches that have been setup to be merged in your config. You want to undo the merge step, but probably not the fetch (doesn't make a lot of sense and shouldn't be necessary).

To undo the merge, use git reset --hard to reset the local repository to a previous state; use git-reflog to find the SHA-1 of the previous state and then reset to it.

Warning

The commands listed in this section remove all uncommitted changes, potentially leading to a loss of work:

git reset --hard

Alternatively, reset to a particular point in time, such as:

git reset --hard master@{"10 minutes ago"}